機械氣動剪板機到貨之后怎樣使用？
第一步接入380V三相電 l1 l2 l3 接入三根火線，先按我們看一下電機是否為正轉，順時針為正轉，如果是反轉，調節這三根線中的其中兩根，我們平常說的叫換項，直到電機順時針轉。
然后再看一下怎樣加油，這個的蓋子加入黃油，這個地方加入機械油。這是搖把和數字顯示。搖把鎖不緊的情況，咱現在來看一下。如果被這個卡住了之后，我們可以把它拉出來之后回去再次向下，直到左右兩邊是一樣的。
下面加注黃油，上面加注機械油，可以參照這個加油銘牌。這個地方也是加注機械油的，所有潤滑的組件在到的時候都可以加速一下機械油，
我們現在來踩一下這個踏板試一下。踩一次就是單次運作，如果你踩著不動的話，它就會連續剪切。好了這就是全部的使用了。
How to use the mechanical pneumatic shearing machine after it arrives?
The first step is to connect the 380V three-phase power L1, L2, and L3 to three live wires. First, check if the motor is rotating in the forward direction. Clockwise rotation is positive. If it is in the reverse direction, adjust two of these three wires. This is commonly referred to as switching until the motor rotates clockwise.
Then let's take a look at how to refuel. Add butter to this lid and mechanical oil to this area. This is a handle and digital display. Let's take a look at the situation where the handle is not locked tightly. If it gets stuck, we can pull it out and go back down again until the left and right sides are the same.
Add butter below and mechanical oil above, refer to this refueling label. This place is also filled with mechanical oil, and all lubricated components can be accelerated with mechanical oil when they arrive,
Let's step on this pedal now and try it out. Stepping on it once is a single operation, and if you don't step on it, it will cut continuously. Alright, that's all for use.
|
|
